Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Car Radio for iPod iPhone Interface Installation

Model: Mazda Cx7 MK 1 - Years: 2006, 2007, 2008, 2009, 2010, 2011, 2012
Part: Car stereo

Video tutorial

Using a small flathead screwdriver, detach the trim surrounding the two knobs of the car radio and the one with the aluminium edge of the central console that also supports the air vents. Then, unscrew the 4 fixing screws of the car radio located at the corners and pull it out from its housing; connect one end of the wiring harness to the iPod device behind the car radio and pass the other end through the space between the two knobs; connect the iPod adapter to this end and position it in the space between the two knobs; finally, pass the cable with the connector for the iPod device through the stereo to place it in the glove compartment.

At this point, re-screw the 4 fixing screws, reattach the previously removed trims, and check the operation of the device.


Updated on 3 February 2026 by ScegliAuto


Related tutorials

Installation of Aux Adapter Accessory Kit and Removal of Car Radio
Installation of Aux Adapter Accessory Kit and Removal of Car Radio
Mazda Cx7 (2006-2012 / MK 1) To install the Aux output for iPhone or iPad, you need to remove the car radio: the first step is to remove the aluminium trim around the central con…
Instructions for Removing the Car Radio
Instructions for Removing the Car Radio
Mazda Cx7 (2006-2012 / MK 1) First, move the gear lever back to facilitate the removal process. Using a small plastic lever, detach the trim around the car radio and climate cont…
Removing Car Radio and Installing Satellite Navigation
Removing Car Radio and Installing Satellite Navigation
Mazda Cx7 (2006-2012 / MK 1) Start by gently removing the plastic trims on either side of the tunnel using just your hands. Remove the screws from the plastic frame and then the …

How to Reset the Tyre Pressure Warning Light on the Jeep Renegade?

To reset the tyre pressure warning light on the Jeep Renegade, inflate the tyres until they reach the recommended pressure: this value is indicated on the sticker attached to the driver’s door pillar. Once the tyres are properly inflated, navigate through the menu that appears on the instrument cluster until you find the tyre pressure option. At this point, press and hold the OK button on the right side of the steering wheel to make the warning light disappear.

Watch the video!


by ScegliAuto

More videos