Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mazda
    3. :
  3. Cx7
    4. : Disassembly of the car radio and installation of the satellite navigator

Mazda Cx7 - Video tutorial

Model: Mazda Cx7 MK 1 - Years 2006-2012
Part: Car stereo
Operation: Disassembly of the car radio and installation of the satellite navigator

Begin to remove the plastic moldings on the sides of the tunnel by gently pulling them using just your hands. Remove the screws of the plastic frame and then the screws of the radio console and gently remove the assembly by lifting it to allow removal of the connectors. Once the radio has been removed, remove the switch fixing screws and remove it carefully. Also remove the connecting cable. Refit the switch on the navigator that you are going to install and reconnect the cable. Before reassembling the navigator, it is essential to install the satellite antenna on the roof and wire the cable up to the radio compartment. Reconnect all the cables to the navigator and place the navigator in the car radio compartment, fixing it with the screws. Reassemble the frame. Switch on the navigator for a correct functioning test.


Posted on 25 June 2023 by ScegliAuto



Installation of the Aux adapter accessory kit and disassembly of the car radio
Mazda Cx7 (2006-2012 / MK 1) In order to install the Aux output for the iPhone or Ipad, the car radio must be removed: the first step is to remove the aluminum frame around the c
Car radio disassembly instructions
Mazda Cx7 (2006-2012 / MK 1) First move the gear lever backwards to facilitate removal. Using a small plastic lever, unhook the frame around the car radio and the air conditionin
Disassembly of the car radio to install the iPod iPhone interface
Mazda Cx7 (2006-2012 / MK 1) With a small fixed screwdriver, unclip the frame around the two knobs of the car radio and the one with the aluminum edge of the center console which

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos