Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Car Radio for Repair

Model: Mazda 6 GG, MK 1 - Years 2002-2008
Part: Car stereo

Due to the delicacy of the work, it is advisable to perform the operation if you have some experience. Remove the gear lever cover and the associated plastic panel by prising at the edges with a plastic tool. Also, remove the gear knob. Disconnect the wiring of the switches and pull it from the gear lever. Unscrew all the screws from the radio and climate control panel frame. Carefully remove the frame by prising on all sides, and then also remove the complete panel by gently pulling it from its housing. Disconnect all the wiring at the back until it is completely removed.

Updated on 6 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Installing Aux Adapter Accessory Kit and Removing Car Radio
Installing Aux Adapter Accessory Kit and Removing Car Radio
Mazda 6 (2008-2012 / GH, MK 2) To install an Aux input, it is necessary to remove the car radio to which the kit's control unit and the corresponding output cable will be connected…
Instructions for Removing the Car Radio
Instructions for Removing the Car Radio
Mazda 6 (2002-2008 / GG, MK 1) To remove the original car radio, the first step is to take off the central tunnel cover: position the gear lever in reverse (in drive position), uns…
How to Remove the Radio from a 2007 Mazda 6 and Replace it with a Touchscreen Stereo
How to Remove the Radio from a 2007 Mazda 6 and Replace it with a Touchscreen Stereo
Mazda 6 (2002-2008 / GG, MK 1) To replace the radio with a touchscreen stereo in a 2007 Mazda 6, follow these steps. First, remove the entire plastic surround around the handbrake,…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos