Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installing a Car Seat Heater

Model: Mazda Mx 5 MK 1 - Years: 1989, 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997
Part: Seat

See other generations:
Video tutorial

This guide shows how to install a car seat heater. Using tools such as a screwdriver, pliers, and a drill, disassemble the various parts of the seat to access its interior and insert the seat heating kit using the provided adhesives.

You can then reassemble the seat by installing new metal wire clips; if the kit runs out, you can also use DIY metal wire clips. Finish the rear part of the seat by replacing all the clips.

After this, the guide demonstrates how to repair the internal foam, a very difficult piece to replace, using contact adhesives.


Updated on 9 February 2026 by ScegliAuto


Related tutorials

Aftermarket Car Radio Installation
Aftermarket Car Radio Installation
Mazda Mx 5 (2005-2015 / NC, MK 3) To install a new aftermarket car radio, you must first remove the factory radio. Start by removing the plastic cover of the reinforcement plate locat…
Installing Aftermarket Car Radio
Installing Aftermarket Car Radio
Mazda Mx 5 (1998-2005 / NB, MK 2) To install the new car radio, you first need to remove the factory unit: remove the plastic trim on the sides of the radio and insert the appropriate…
Instructions for Dismantling the Car Radio
Instructions for Dismantling the Car Radio
Mazda Mx 5 (2005-2015 / NC, MK 3) The first operation to perform is to remove the plastic trims around the car radio and the climate control buttons: start by removing the plastic tri…

How to Remove the Toll Tag Holder from the Car Windscreen

The toll tag holder is usually attached to the car windscreen to ensure that the toll tag functions immediately when passing through barriers. However, if you decide to remove the holder, you should follow this procedure: - Insert the toll tag into the holder; - Pull the holder inwards to detach it from the windscreen; you can use a glass scraper or a stiff plastic card to assist you; After removing the holder, it is essential to remove the adhesive from the windscreen. To remove the adhesive, we recommend using a solvent-based spray that will remove the glue without clouding the area.

Watch the video!


by ScegliAuto

More videos