Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Clutch and Flywheel

Model: Mazda Rx 8 MK 1 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012
Part: Clutch

Video tutorial

Replacing these components is a job that requires experience and good equipment. First, remove the undertray from the bottom of the car to facilitate the removal of the exhaust (this makes the job less complicated) and the driveshaft.

After removing these components, disconnect the gearbox from the engine: this operation should be done with the aid of a hoist. Now you can remove the clutch release bearing and the clutch itself, along with the flywheel.

Once the components are removed, replace them with new parts, and the gearbox-engine assembly can be reassembled.


Updated on 10 February 2026 by ScegliAuto


Related tutorials

Engine Air Filter Replacement
Engine Air Filter Replacement
Mazda Rx 8 (2003-2012 / MK 1) Open the engine bonnet: the filter is located at the front of the engine. Release the bayonet clips of the filter housing and push it backwards to sl…
Replacing Engine Oil and Oil Filter
Mazda Rx 8 (2003-2012 / MK 1) Lift the vehicle using appropriate car ramps and unscrew the drain plug of the oil sump located on the side, collecting the used oil in a suitable co…
How to Replace the Rear Brake Pads on the Mazda RX-8?
How to Replace the Rear Brake Pads on the Mazda RX-8?
Mazda Rx 8 (2003-2012 / MK 1) To replace the rear brake pads on the Mazda RX-8, lift the car with a jack or ramp so you can unscrew the fixing bolts of the corresponding wheel. Th…

Other guides you may be interested in

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos