Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removal and Replacement of the Seatbelt

Model: Mazda 3 MK 2, BL - Years 2009-2013
Part: Seat

First, use a plastic trim tool to remove the plastic covers located at the bottom (towards the inside) under the lower edge of the front and rear doors. Now remove the plastic cover of the seatbelt mechanism. This is located in the pillar between the two doors and can be removed by prying at the edges to disengage it. At this point, remove the plastic cover from the upper pivot of the seatbelt, again prying to disengage it. Now proceed to unscrew the bolt that secures the seatbelt at the upper pivot. Also, unscrew the bolts (using the appropriate spanner) that secure the mechanism and the seatbelt at the bottom. Disconnect the electrical supply and the job is done. This operation is performed on a Mazda 3.

Updated on 20 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Removal of the Original Car Radio
Removal of the Original Car Radio
Mazda 3 (2009-2013 / MK 2, BL) Removing the factory car radio is important if you want to install a better, newer one or if the current one is malfunctioning. It is clipped in plac…
Removing Front Handle on Mazda 3
Removing Front Handle on Mazda 3
Mazda 3 (2009-2013 / MK 2, BL) To remove the handle from your Mazda 3, simply open the door and using a pointed tool, preferably plastic, remove the rubber cap that will allow you …
Removing the Windscreen Pillar Trim
Removing the Windscreen Pillar Trim
Mazda 3 (2003-2009 / BK, MK 1) To remove the plastic trim of the windscreen pillar, note that the pillar is secured with two push clips (one at the bottom and one at the top) and i…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos