Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Car Door Panel

Model: Mazda Cx 7 MK 1 - Years 2006-2012
Part: Door trim panel

This guide explains how to remove the door panel of your car. With a bit of dedication and passion, DIY is possible. The door panel is not difficult to remove during disassembly. Simply locate the screws present in the panel and detach the profile. Take care to remove the screws on the panel with a magnetic screwdriver. Finally, unscrew the support screws located beneath the central panel. Once all screws are removed, you can proceed to slide off the panel to be replaced.

Updated on 21 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the timing chain in Mazda Cx7
How to replace the timing chain in Mazda Cx7
Mazda Cx 7 (2006-2012 / MK 1) In this video we are going to see how to replace the timing chain in the Mazda Cx7. It should be known that it should be replaced approximately every…
Removing the Plastic Engine Cover
Removing the Plastic Engine Cover
Mazda Cx 7 (2006-2012 / MK 1) To remove the plastic cover applied directly to the engine, first, extract the two expansion clips at the front ends that secure the cover to the sla…
Removal of the Front Door Panel
Removal of the Front Door Panel
Mazda Cx 7 (2006-2012 / MK 1) Locate the screws that secure the panel. One is above the lever to open the car and the other is at the bottom of the handle. Remove the small plasti…

Installation of Upgraded Intercooler Radiator with Pipes

Lift the vehicle on suitable axle stands, remove the front wheels, and then the front bumper and grille. Proceed to remove the front headlights; drain the coolant, remove the intercooler radiator and the hoses connecting it to the intake system. Position the new intercooler radiator in the grille, temporarily securing it with cable ties, and mark with a marker the part of the metal that needs to be removed to allow the new hoses to pass through. Cut the marked portion of metal and apply a gasket to the edge. Remove the inner cover of the bumper and position it near the radiator to identify any interfering parts to eliminate: again, apply a gasket to the edge of the cut. Create brackets for securing the new radiator and proceed with the installation of the connecting pipes from the radiator to the intake, shaping and connecting them appropriately. Finally, reassemble the bumper, headlights, and grille.

Watch the video!


by ScegliAuto

More videos