Automatic Transmission Fluid Replacement

Model: Mercedes Classe E W211 - Years: 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009
Part: Transmission fluid

See other generations:

This video is currently unavailable

Before proceeding with the automatic transmission fluid replacement, ensure you have the appropriate ATF fluid, the filter cartridge, and the pan gasket. Lift the vehicle on a lift or on suitable jack stands; remove the drain plug and collect the used fluid in a container; then remove the pan retaining bolts and pull out the filter cartridge (just pull it down).

Clean the pan thoroughly, removing any metal debris that may have collected on the magnet. The video shows the transmission draining by starting the engine and shifting through the gears while leaving the transmission pan removed: be cautious with this operation as it could damage the transmission; if necessary, the flushing should be done with the appropriate equipment that injects new fluid while sucking out the old, keeping the gears lubricated.

Then install the new filter cartridge, the new gasket on the pan, and secure it by tightening the retaining bolts. Fill the transmission with new fluid, start the engine, and cycle through all the gear positions.

Finally, check the fluid level using the appropriate dipstick.

Updated on 7 February 2026 by ScegliAuto

Other guides you may be interested in

- Maintenance and repair on other vehicles

Engine - Maintenance and repair on other vehicles

Transmission Fluid - Maintenance and repair on other vehicles

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!

by ScegliAuto

Automatic Transmission Fluid Replacement

Related tutorials

Other guides you may be interested in

How to Reset the Tire Pressure Light on a MG ZS?

More videos