Do it yourself
| ||||
|
Mercedes Clk - Video tutorial
Model: Mercedes Clk
W208
- Years 1997-2003 When the silent block bushings of the oscillating arms of the suspensions fail, a lot of noises are heard in the passenger compartment, especially when driving on rough terrain: the collapse of the rubber part is no longer able to attenuate and dampen vibrations; in these cases it is possible to opt for the replacement of the entire oscillating arm or for its regeneration by replacing only the bushings: in any case it is necessary to lift the car and remove the front wheel; then proceed with the disassembly of the fixing pins of the oscillating arm and it would be better to disassemble it completely to replace the bench bushings; but if you want to avoid it, support the suspension with a jack and lower the bush seat in order to extract the old one by making a cut with a hacksaw blade; once the old bushing has been removed, insert the new one with a hammer and reinstall the swinging arm.
Posted on 22 August 2023 by ScegliAuto
Silent block bush replacement
Mercedes Clk (1997-2003 / W208) In case of failure of the rubber bush applied to the suspension arm connected to the steering box tie rod, it can be replaced very quickly and econom
Car arm replacement
Mercedes Clk (1997-2003 / W208) The suspension arm of the car ensures the connection between the frame and the struts. However, this can wear out over time or collide and a faulty a
Rear shock absorber replacement
Mercedes Clk (1997-2003 / W208) The replacement of the rear shock absorbers is much easier to carry out than the front ones since the spring and the shock absorber are not coaxial a Other guides that may interest you
|
Fiat Ducato 2.8 JTD gearbox oil replacementLet's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level! by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.048
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |