|
Do it yourself
| |||
| ||||
Replacing the Lower Suspension Control Arm
Model: Mercedes Classe C
W204
- Years:
2007, 2008, 2009, 2010, 2011, 2012, 2013
Video tutorial
The lower control arm of the front suspension consists of a ball joint attached to the hub support and a bushing with a silent block secured with a pin to the engine cradle. To replace it, lift the vehicle and remove the front wheel. Then, unscrew the retaining nut of the ball joint and use a forked puller to free it from the hub support. Next, unscrew the retaining pin of the bushing and remove the control arm to install the new one. Once the bushing is secured to the cradle, apply a jack under the suspension to support it enough to insert the ball joint into its seat and secure it.
Updated on 20 February 2026 by ScegliAuto
Related tutorials
Mercedes Classe C
(1983-1993 /
)
Lift the vehicle and remove the wheel corresponding to the repair area.
Using appropriate clamps, compress the suspension spring until you can remove…
Mercedes Classe C
(1993-2000 /
W202)
Lift the vehicle at the wheel where the repair will be made, remove the wheel, and apply a jack stand.
Then, apply two clamps to the suspension sprin…
Mercedes Classe C
(2000-2007 /
W203)
The front suspension control arm consists of a ball joint connected to the wheel hub support and a silent block bushing that attaches directly to the…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.
Other guides you may be interested in
|
Where is the battery located on the Aprilia Scarabeo 250ie scooter?
This video shows where the battery is located on the Aprilia Scarabeo 250ie scooter and how to proceed if you need to replace it. As shown, it is located beneath the seat. To access and replace it, first open the seat, then remove the plastic cover by unscrewing the relevant screws with a cross-head screwdriver. Next, disconnect both terminals, starting with the negative, remove the battery from its housing, and install the new replacement following the reverse procedure. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.082
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy - About us VAT number: IT01247470535 |