Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to reset the tire pressure sensor of the MG 3

Model: MG 3 MK 1 - Years 2008-2011
Part:

If the tire pressure warning light continues to appear on the instrument panel of your first series MG 3 even if there are no punctures, then you must proceed with the manual reset of the warning light. Below we will explain how to do it. First of all, get into the car and turn on the ignition, then press the button located at the end of the left steering wheel lever several times. Once you see the message "TPMS Reset?" on the display, hold down the same button used previously and wait for the tire pressure warning light reset to complete. Finally, release the button and you are done.

Posted on 28 April 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Airbag Light on the MG 3
How to Reset the Airbag Light on the MG 3
MG 3 (2011-2024 / MK 2) If the airbag light appears on the instrument cluster of your MG 3 Mk2 without an actual problem with the system, you will need to perform a manual r…
Reset TPMS on a MG 3
Reset TPMS on a MG 3
MG 3 (2011-2024 / MK 2) In today's tutorial, we can see how to reset the TPMS light, which is the tire pressure warning light, on an MG 3, second-generation restyling model …
Where to Find the Vehicle Identification Codes on the MG 3?
Where to Find the Vehicle Identification Codes on the MG 3?
MG 3 (2011-2024 / MK 2) The Vehicle Identification Number, also known as VIN, is located under the windshield at the bottom on the passenger side. The same number can be fou…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos