Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Nissan
    3. :
  3. Qashqai
    4. : How to remove the front bumper of the Nissan Qashqai

Nissan Qashqai - Video tutorial

Model: Nissan Qashqai J11 - Years 2014-2022
Part: Front bumper
Operation: How to remove the front bumper of the Nissan Qashqai

The guide shows how to remove the front bumper of the Nissan Qashqai for the model produced in 2019. The first operation to be performed is to open the engine hood and start removing the radiator grille; to do this it is necessary to remove the four clips with the help of a screwdriver. The grille is held in position, at the front, by some plastic clips; to remove it, just apply some pressure. The four fixing clips of the radiator support can now be removed. Under the nose of the vehicle, the retaining clips can be removed and, with a Torx wrench, the fender can be removed. In the wheel arch there are other Torx screws to be removed. There is a bolt to be removed under the wheel arch body. Now it is possible to remove the bumper, paying attention to the fixing clips and the connectors of the fog lights. The assembly of the part is completed by carrying out the operations described up to now in reverse.


Posted on 9 February 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Qashqai 2014-2022 - How do you disassemble the right front fender of the Nissan Qashqai 2017? Read Answer

Replace the steering angle sensor on the Volkswagen Golf 5

When the steering angle sensor malfunction warning light comes on, it may need to be replaced as follows: first remove the steering wheel and the lower steering wheel guard by removing the three fixing screws. The steering sensor is located just below the steering column. To release it you need to have a small screwdriver and insert it into the hole on the front, push the screwdriver all the way down until the clips at the bottom are released. Next, pull down on the back of the card containing the sensor and disengage it from the steering column. At that point take the new card and reposition it, after which proceed backwards to reassemble the various components.

Watch the video!


by ScegliAuto

More videos