Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Vauxhall
    3. :
  3. Corsa
    4. : Removal of the tappets and cylinder head Opel Corsa 1.2 Petrol

Vauxhall Corsa - Video tutorial

Model: Vauxhall Corsa Corsa C - Years 2000-2006
Part: Engine head
Operation: Removal of the tappets and cylinder head Opel Corsa 1.2 Petrol

We see in this video the main instructions to be able to disassemble the tappets and the cylinder head of an Opel Corsa 1.2 Petrol. First we open the bonnet and we go to remove the intake sleeve and the air filter box, disconnecting the electrical connector of the mass / air sensor; after which we remove the throttle body, unscrewing the screws and disconnecting the various electrical cables, and remove the four spark plugs using a socket wrench. At this point we remove the injectors and disconnect the radiator liquid pipe and remove the cylinder head cover; follow the video tutorial to the end!


Posted on 7 January 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Corsa 2014-2019 - How much does it cost to replace the cylinder head gasket in the Opel Corsa? Read Answer
    • Corsa 2014-2019 - How much does it cost to repair the cylinder head gasket on the Opel Corsa? Read Answer
    • Corsa 2006-2014 - How much does the cylinder head of the Opel Corsa D cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos