Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removal of the ABS Control Unit

Model: Vauxhall Vectra Vectra B, MK 2 - Years: 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002
Part: Brake system

See other generations:
Video tutorial

The ABS control unit is located on the right side of the fuse box inside the engine bay. To extract it, you need to unclip and lift the coolant reservoir and the fuse box. Once the necessary space is cleared, remove the six Torx screws located on the edge of the module, which secure the control unit to the pump, and it can be extracted.

Once the connector is disconnected, you can proceed with replacing the control unit.

When disassembling the fuse box, be careful not to break the plastic clips that secure it, and the coolant reservoir must be placed in the correct positions.


Updated on 8 February 2026 by ScegliAuto


Related tutorials

How to Remove the ABS Control Unit on the Opel Vectra
How to Remove the ABS Control Unit on the Opel Vectra
Vauxhall Vectra (1995-2002 / Vectra B, MK 2) To replace the ABS control unit on this car model, follow the instructions and steps outlined below. After opening the bonnet, the control unit is lo…
Where is the Ignition Fuse on a 2003 Opel Vectra?
Where is the Ignition Fuse on a 2003 Opel Vectra?
Vauxhall Vectra (2002-2008 / Vectra C, MK 3) The ignition fuse for the 2003 Opel Vectra is located inside the fuse box under the bonnet, specifically near the battery. This fuse is identifiable …
Removing the Steering Wheel Controls on an Opel Vectra C
Vauxhall Vectra (2002-2008 / Vectra C, MK 3) Today, you will see in this short and simple video the steps necessary to remove and replace the controls or buttons on the steering wheel of the Ope…

Other guides you may be interested in

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos