Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Gas Struts on the Opel Meriva

Model: Vauxhall Meriva Meriva A, MK 1 - Years 2003-2010
Part: Hydraulic pistons

In today's video tutorial, you will learn how to remove and replace the gas struts of the rear tailgate on the Opel Meriva by following these simple steps. First, open the rear tailgate and hold it up; then proceed to remove the gas strut by first taking off the small plastic clip and then detaching it from the bottom, as shown in the video. At this point, install the new gas strut correctly, securing it in place; repeat the same procedure to replace the other strut!

Updated on 10 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Two Hydraulic Struts of the Boot on an Opel Meriva
How to Replace the Two Hydraulic Struts of the Boot on an Opel Meriva
Vauxhall Meriva (2003-2010 / Meriva A, MK 1) Before you can start, open the rear tailgate of your Opel Meriva. Begin by releasing the clips that secure the struts using a flathead screwdriver as…
How do you remove the EGR valve in the Opel Meriva 1.3 CDTI?
How do you remove the EGR valve in the Opel Meriva 1.3 CDTI?
Vauxhall Meriva (2003-2010 / Meriva A, MK 1) In this video tutorial, we will see how to disassemble an Egr valve of the Opel Meriva 1.3 cdti, which is responsible for recovering a percentage of …
How do you disassemble the EGR valve in the Opel Meriva?
How do you disassemble the EGR valve in the Opel Meriva?
Vauxhall Meriva (2010-2017 / MK 2, Meriva B) The EGR valve has the important task of reducing car pollution, as it recovers and reuses a percentage of exhaust gases and channels them into the en…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos