Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Vauxhall
    3. :
  3. Meriva
    4. : How to remove the front headlight and bumper of the Opel Meriva.

Vauxhall Meriva - Video tutorial

Model: Vauxhall Meriva MK 1, Meriva A - Years 2003-2010
Part: Front bumper
Operation: How to remove the front headlight and bumper of the Opel Meriva.

Let's briefly go over the instructions that will allow us to disassemble and replace the front headlight and bumper of the Opel Meriva. First, we open the engine hood and begin to disassemble and remove the front bumper by unscrewing all the fixing screws. Then, we proceed to unscrew the side screws of the front headlight, disconnecting the electrical connector of the bulbs in order to remove it, as shown in the video. At this point, if necessary, we replace the bulbs or directly the entire optical group with the new one. Finally, we reassemble the front headlight by following the reverse procedure.


Posted on 7 August 2023 by ScegliAuto



How do you remove the headlight of the Opel Meriva?
Vauxhall Meriva (2003-2010 / MK 1, Meriva A) In order to remove the headlight of the Opel Meriva it is necessary to lift the front hood of the car, so that the screws that secure the bumper at t
Opel Meriva headlight bulb replacement
Vauxhall Meriva (2003-2010 / MK 1, Meriva A) Let's see below the steps necessary to disassemble and replace the low beam bulb of the front headlight of the Opel Meriva. First of all, we open the
How to mount the front bumper of the Opel Meriva B
Vauxhall Meriva (2010-2017 / Meriva B, MK 2) When installing a new bumper, before proceeding with the relative painting, a preliminary assembly is suggested to check that it fits correctly in it

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos