Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Vauxhall
    3. :
  3. Meriva
    4. : How to disassemble the front bumper of an Opel Meriva?

Vauxhall Meriva - Video tutorial

Model: Vauxhall Meriva Meriva A, MK 1 - Years 2003-2010
Part: Front bumper
Operation: How to disassemble the front bumper of an Opel Meriva?

To remove the front bumper of an Opel Meriva, start by lifting the hood and locate the upper fixing screws of the bumper, usually located under the front part of the hood itself. Use a screwdriver or a suitable key to remove them. Then, position yourself under the vehicle and look for the fixing screws or bolts on the lower edge of the bumper. Remove them using the appropriate tools. After removing the screws or bolts, check if there are fixing clips along the sides of the bumper. Use a plastic tool to gently detach the clips. Once all the fixing elements have been removed, you can proceed to release the bumper by gently pulling it outwards and upwards. Pay attention to the electrical connectors, if present, for parking sensors or fog lights. Disconnect them carefully to avoid damaging the cables. Once the bumper is removed, make any necessary repairs or replacements. For reassembly, follow the steps in reverse order, making sure to reconnect the connectors and securely fasten all fixing elements.


Posted on 3 May 2024 by ScegliAuto

Other guides that may interest you

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos