Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Engine Oil Filter of the Opel Antara 2.0 CDTI

Model: Vauxhall Antara MK 1 - Years 2006-2015
Part: Oil filter

Here are the instructions to remove and replace the oil filter of the Opel Antara 2.0 CDTI, as well as the Chevrolet Captiva. First, open the bonnet and start by removing the plastic engine cover; then disconnect the intake hose from the air filter box, as shown in the video. At this point, move the diesel filter to access the engine oil filter located at the bottom; then remove and replace the cartridge with a new one, tightening gently with a spanner.

Updated on 12 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Carry Out a Service on an Opel Antara
How to Carry Out a Service on an Opel Antara
Vauxhall Antara (2006-2015 / MK 1) Let's go through the steps to perform the regular maintenance service, replacing the engine oil and oil filter on the Opel Antara Diesel. First, lift…
Replacing the Fuel Filter on an Opel Antara
Replacing the Fuel Filter on an Opel Antara
Vauxhall Antara (2006-2015 / MK 1) Let’s see how to remove the fuel filter on an Opel Antara. Lift the car with a jack. Unscrew the fastening bolts near the container (disconnect the c…
How to Reset the Service Light in the Opel Antara?
How to Reset the Service Light in the Opel Antara?
Vauxhall Antara (2006-2015 / MK 1) The procedure to turn off the Service light in the Opel Antara is very simple, takes very little time, and does not require any tools to be connected…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos