Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 406
    4. : License plate light

Peugeot 406 - License plate light

Peugeot 406 (1995-2005 / MK 1)
Replacing the license plate light and checking the bulb holder contacts
First operate the light switch and check if one or more bulbs of the license plate light work or not. In case you need to replace them, use a thin screwdriver …read all…
Posted on 22 July 2023 by ScegliAuto
Airbags (2) Alternator (1) Shock absorbers (1) Antenna (1) Air conditioning (1) Car stereo (1) Coil (1) Arm (2) Gearbox (2) Bodywork (2) Glove box (1) Control unit (1) Key (2) Timing belt (4) -board computer (2) Checks and maintenance (3) Dashboard (3) Bearing (2) Air filter (1) Cabin air filter (4) Hand brake (1) Clutch (3) Injectors (1) Window lift switch (2) Accessory Kit (1) Light bulb (1) Dashboard light (1) License plate light (1) Muffler (1) Starter motor (2) Engine oil (2) Door panel (2) Front bumper (1) Rear bumper (2) Brake pads (2) Fuel pump (3) Door (3) Push button (2) Instrument cluster (3) Passenger compartment heating radiator (1) Fuse box (4) Seat (3) Brake system (1) Suspensions (2) Outside rearview mirror (2) Drums and shoes (1) Windscreen wipers (1) Thermostat (1) Engine head (1) Transmission (1) Valve (1) Interior blower (2) Side window (1)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos