Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 406
    4. : Fuel pump

Peugeot 406 - Fuel pump

Peugeot 406 (1995-2005 / MK 1)
How to disassemble the fuel pump in Peugeot 406?
In this tutorial we can see how to disassemble the fuel pump in the Peugeot 406, an operation to be carried out in case we need to replace the float or the …read all…
Posted on 18 September 2022 by ScegliAuto
Peugeot 406 (1995-2005 / MK 1)
How to disassemble and replace the float pump on the Peugeot 406
In this video tutorial we will see how to disassemble and replace the float pump or fuel pump on the Peugeot 406 first series, following these simple steps. …read all…
Posted on 29 February 2024 by ScegliAuto
Peugeot 406 (1995-2005 / MK 1)
Pump and float removal
This video shows us how to remove the fuel pump. First you need to remove the rear seats as they are located right above the tank with attached pump. The seats …read all…
Posted on 28 July 2023 by ScegliAuto
Airbags (2) Alternator (1) Shock absorbers (1) Antenna (1) Air conditioning (1) Car stereo (1) Coil (1) Arm (2) Gearbox (2) Bodywork (2) Glove box (1) Control unit (1) Key (2) Timing belt (4) -board computer (2) Checks and maintenance (3) Dashboard (3) Bearing (2) Air filter (1) Cabin air filter (4) Hand brake (1) Clutch (3) Injectors (1) Window lift switch (2) Accessory Kit (1) Light bulb (1) Dashboard light (1) License plate light (1) Muffler (1) Starter motor (2) Engine oil (2) Door panel (2) Front bumper (1) Rear bumper (2) Brake pads (2) Fuel pump (3) Door (3) Push button (2) Instrument cluster (3) Passenger compartment heating radiator (1) Fuse box (4) Seat (3) Brake system (1) Suspensions (2) Outside rearview mirror (2) Drums and shoes (1) Windscreen wipers (1) Thermostat (1) Engine head (1) Transmission (1) Valve (1) Interior blower (2) Side window (1)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos