Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 2008
    4. : How to replace the rear light unit in Peugeot 2008

Peugeot 2008 - Video tutorial

Model: Peugeot 2008 MK 1 - Years 2013-2019
Part: Tail light
Operation: How to replace the rear light unit in Peugeot 2008

To replace the rear light block in the Peugeot 2008, we put the car on the bridge or on a well-immobilized surface. Now, we open the tailgate of the luggage compartment at the rear and, inside the luggage compartment itself, in the side wall, in correspondence with the light we want to replace, we find a small handle that allows us to open the compartment for access to the nut (to be unscrewed by hand) that holds the headlight locked in place in its seat. Once this nut has been unscrewed, we can remove the headlight block, disconnect the electrical contacts of the headlight itself and replace it with the new one. We repeat the same operations seen, but proceeding backwards, for the assembly of the new lighthouse.


Posted on 22 November 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Peugeot 2008 2019-2026 - How to disassemble the rear light of the Peugeot 2008? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos