Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 306
    4. : Replacement discs and front pads

Peugeot 306 - Video tutorial

Model: Peugeot 306 MK 1 - Years 1993-2002
Part: Brake pads
Operation: Replacement discs and front pads

Raise the car on suitable car stands and remove the front wheel (loosen the pins before lifting); extract the safety split pin and then the pin fastening the pads to the caliper, extract the pads by disconnecting the wear sensor; check the sliding of the caliper and remove it from the hub support in order to free the disc; unscrew the pins fixing the disc to the hub and remove it from its seat; clean the disc seat with an iron brush and apply grease before installing the new disc after having cleaned it of protective oil; re-enter the caliper barrel using an arc clamp, reassemble it and insert the nine pads, fixing them with the pin and the safety split pin.


Posted on 13 August 2023 by ScegliAuto



Guide to disassembling the front door of the Peugeot 306
Peugeot 306 (1993-2002 / MK 1) The steps outlined in this guide will show us the process of disassembling and replacing the door of the Peugeot 306. First, we open the front door a
Peugeot 306 HDI engine disassembly guide
Peugeot 306 (1993-2002 / MK 1) In today's video we will see the main instructions that will allow us to disassemble and replace the entire engine block of the Peugeot 306 HDI. Firs
Disassembling the door panel of the Peugeot 306.
Peugeot 306 (1993-2002 / MK 1) Today we will see the main instructions that will allow us to disassemble and replace the front door panel of the Peugeot 306. First of all, we open

How do I replace the Land Rover Evoque auxiliary battery?

In order to replace the auxiliary battery of the Land Rover Evoque, it is necessary to go inside the passenger compartment and remove the panel which is positioned immediately under the glovebox. Once the screws that secure this panel have been loosened, it will be possible to access the components located in its rear part, including the auxiliary battery. The latter must be disconnected from its cables and the fixing screws must be loosened. The battery can then be replaced with a new one and the panel can be fixed again with its screws.

Watch the video!


by ScegliAuto

More videos