Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 207
    4. : Replacement of the starter motor of the Peugeot 207.

Peugeot 207 - Video tutorial

Model: Peugeot 207 MK 1 - Years 2006-2015
Part: Starter motor
Operation: Replacement of the starter motor of the Peugeot 207.

Today we will see the procedure necessary to disassemble and replace the starter motor of the Peugeot 207. First, we open the engine hood of the car and start by removing the battery, disconnecting both battery terminals and unscrewing the bracket screw. Then, we unscrew the first screws of the starter motor, and then lift the car to be able to unscrew the additional screws, as shown in the video. At this point, we disconnect the wiring of the starter motor to remove it, replacing it with the new original one. Let's reassemble the new starter motor!


Posted on 15 September 2023 by ScegliAuto

    Frequently Asked Questions

    • 207 2006-2015 - Where is the starter motor of the Peugeot 207 located? Read Answer
    • 207 2006-2015 - Where is the starter motor of the Peugeot 207 located? Read Answer
    • 207 2006-2015 - Where is the starter motor of the Peugeot 207 located? Read Answer
    • 207 2006-2015 - What to do with the Peugeot 207 starting problem? Read Answer
    • 207 2006-2015 - What problem can the starter motor of a Peugeot 207 cause? Read Answer
    • 207 2006-2015 - Where is the starter motor located on the Peugeot 207? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos