Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 2008
    4. : How to repair the third stop of the Peugeot 2008

Peugeot 2008 - Video tutorial

Model: Peugeot 2008 MK 1 - Years 2013-2019
Part: Third brake light
Operation: How to repair the third stop of the Peugeot 2008

The bulbs of the third stop located in the center of the upper band of the rear bonnet are already of the LED type, therefore in order to replace them it is basically a matter of desoldering the non-working LED and then soldering a new one, which requires in addition to the appropriate equipment , even a minimum of familiarity with tin soldering; having said that, to carry out the repair you must first remove the third stop: then open the rear hood, remove the cap applied to the center of the upper trim strip and then also remove the side trim to access the fixing nuts of the third stop and be able to do it remove; then disassemble the headlight to access the printed circuit on which the LEDs are applied, replace the one or those that are not working, perform a functional check by powering the LEDs and then proceed backwards for reassembly.


Posted on 26 September 2023 by ScegliAuto

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos