Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Porsche
    3. :
  3. 911
    4. : How to replace the starter motor on Porsche 996

Porsche 911 - Video tutorial

Model: Porsche 911 996 - Years 1997-2005
Part: Starter motor
Operation: How to replace the starter motor on Porsche 996

Remove the starter motor of the car? Let's see how it disassembles on a Porsche. We disconnect the cables of the car battery power supply. We remove the container of the engine air filter (with socket wrench). We disconnect the terminals of the starter motor power supply with a pliers or screwdriver. With a socket wrench we unscrew the locking pins on the sides of the starter motor and remove it from the engine compartment. We assemble the new ignition motor with the power supply cables and with the attached tightening screws. We mount the air filter container. We test the Porsche vehicle.


Posted on 20 December 2023 by ScegliAuto



How to remove the starter motor on Porsche 911
Porsche 911 (1997-2005 / 996) Let's see how to remove the starter motor on a Porsche 911. To begin with, we disconnect the cables from the car battery power supply with a socket w
Front bumper installation
Porsche 911 (1997-2005 / 996) Here is a video showing how the front bumper is mounted on the Porsche BBMD or the Porsche Boxster. First place the bumper on the front of the car an
Porsche 996 roof gasket replacement
Porsche 911 (1997-2005 / 996) In this video we will see the instructions on how to remove and replace the sunroof gasket of a Porsche 996. First we will open the roof from inside

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos