Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Porsche
    3. :
  3. 911
    4. : Starter motor

Porsche 911 - Starter motor

Starter Motor Porsche 911 (1997-2005 / 996)

Porsche 911 (1997-2005 / 996)
How to Replace the Starter Motor on a Porsche 996
Remove the starter motor from the car? Let's see how to do it on a Porsche. Disconnect the battery cables. Remove the engine air filter housing (using a socket …Read all…
Posted on 26 April 2026 by ScegliAuto
Porsche 911 (1997-2005 / 996)
How to Remove the Starter Motor on a Porsche 911
Let's see how to remove the starter motor on a Porsche 911. First, use a socket wrench to disconnect the battery power cables. Lift the car on a column lift, …Read all…
Posted on 22 March 2026 by ScegliAuto
Car stereo (1) Battery (1) Ignition coil (1) Control arm (2) Transmission (1) Spark plugs (4) Convertible top (2) Body (6) Key (11) V-belt (1) Checks and maintenance (4) Dashboard (1) Bearing (1) Brake rotors (6) Headlight (8) Tail light (1) Air filter (1) Cabin air filter (3) Oil filter (1) Accessory kit (3) Headlight bulb (1) Interior dome light bulb (1) Antifreeze coolant (2) Exhaust muffler (1) Engine (3) Starter motor (2) Transmission fluid (1) Engine oil (9) Clock (1) Door trim panel (6) Front bumper (5) Rear bumper (3) Brake pads (1) Hydraulic pistons (1) Shift knob (1) Pump (3) Fuel pump (2) Car door (1) Instrument cluster (3) Radiator (2) Wheel (3) Fuse box (5) Seat (1) Side mirror (2) (3) Tire pressure warning light (1) Service warning light (1) Windshield wipers (3) Center console tunnel (1)

How to Connect the Cables to the Battery of the Citroen Xsara Picasso?

In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive.

Watch the video!


by ScegliAuto

More videos