Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Porsche
    3. :
  3. 911
    4. : Pump

Porsche 911 - Pump

Porsche 911 (1997-2005 / 996)
Porsche 911 water pump disassembly
In this video tutorial we will see how to disassemble the water pump in a Porsche 911 Carrera. First we open the rear engine hood and go and remove the timing …read all…
Posted on 24 December 2023 by ScegliAuto
Porsche 911 (1997-2005 / 996)
How to replace the water pump
This video illustrates how to replace the water pump of the Porsche 911. Start by unscrewing the two 13 mm screws that block the engine ventilation system and …read all…
Posted on 2 July 2023 by ScegliAuto
Porsche 911 (1997-2005 / 996)
How to replace the pump in a short time
Do you need to replace the pump? The guide teaches you how to go about doing the task smoothly. Once the bonnet is opened at the bottom left you will find the …read all…
Posted on 30 June 2023 by ScegliAuto
Battery (3) Coil (1) Arm (2) Gearbox (1) Spark plugs (3) Soft top (2) Bodywork (2) Key (5) V-belt (1) Checks and maintenance (5) Dashboard (1) Bearing (1) Brake discs (6) Headlight (6) Tail light (1) Air filter (1) Cabin air filter (3) Oil filter (1) Accessory Kit (3) Headlight bulb (1) Interior lights ceiling light bulb (1) Antifreeze liquid (2) Muffler (1) Engine (3) Starter motor (2) Gear oil (1) Engine oil (8) Door panel (5) Front bumper (5) Rear bumper (3) Brake pads (1) Hydraulic pistons (1) Gear Shift Knob (1) Pump (3) Fuel pump (2) Instrument cluster (3) Radiator (2) Wheel (3) Fuse box (3) Seat (1) Outside rearview mirror (2) Windscreen wipers (3) Central tunnel (1)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos