Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Guide to Replacing the Windshield Washer Fluid Reservoir on the Porsche 911

Model: Porsche 911 996 - Years 1997-2005

In this brief guide, discover the steps to remove and replace the windshield washer fluid reservoir on the Porsche 911. First, lift the vehicle and begin removing the left front wheel; then, unscrew the fasteners of the wheel well to remove it, gaining access to the washer fluid reservoir. At this point, disconnect the fluid hoses and the electrical connector of the pump; unscrew the reservoir screws to remove it and replace it with the new one, using the original part, reconnecting it, and finally pouring in the new fluid!

Updated on 7 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Windshield Washer Fluid Reservoir on a Porsche 911
How to Replace the Windshield Washer Fluid Reservoir on a Porsche 911
Porsche 911 (2005-2011 / 997) To replace the windshield washer fluid reservoir on a Porsche 911, lift the car with a jack so that the front left wheel is not in contact with the g…
How to Replace the Radiator Fluid on a Porsche 911
How to Replace the Radiator Fluid on a Porsche 911
Porsche 911 (2011-2019 / 991) Let's see how to top off the radiator fluid (specific cap) on a Porsche 911. First, pull the plastic lever located at the bottom left of the dashboar…
How to Replace the Coolant in a Porsche 911
How to Replace the Coolant in a Porsche 911
Porsche 911 (2005-2011 / 997) Today, follow these instructions to replace the engine coolant in your Porsche 911. First, lift the vehicle and start loosening the 6 mm hex screw on…

Other guides you may be interested in

    Frequently Asked Questions

    • 911 1997-2005 - How much does it cost to change the IMS bearing on a Porsche 997? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos