|
Do it yourself
| |||
| ||||
What to Do When the Battery Warning Light Comes On in the Renault Master III
Model: Renault Master
MK 3
- Years:
2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021
Video tutorial
The battery warning light coming on after a few minutes of driving is unfortunately a common issue in the Renault Master. The problem is not the battery, but an intermittent signal from the alternator to the control unit, which makes the system think that the charge is insufficient. The first step is to check the charging voltage with a multimeter, measuring the voltage at the battery terminals: the correct and stable value should be around 14.2 volts. If it drops below this value or fluctuates, then there is a fault with the alternator. However, the core of the problem is the regulation signal from the alternator to the engine control unit: this signal travels on a thin two-wire cable, which carries the 12V power for excitation and the monitoring wire (the green wire in the video). This wire sends the regulation signal to the control unit. In the video, the issue was not the wires, but the connector itself that plugs into the alternator. The pins of the connector were making intermittent contact, causing the signal loss and illuminating the warning lights. Replacing it was sufficient to resolve the issue.
Posted on 6 June 2026 by ScegliAuto
Related tutorials
Renault Master
(2010-2023 /
MK 3)
On the instrument panel of the Renault Master, it will be possible to completely turn off the Service light by turning on the instrument panel, turni…
Renault Master
(2010-2023 /
MK 3)
On the instrument panel of the Renault Master, it will be possible to make the Service light disappear completely by turning the key inside the corre…
Renault Master
(2010-2023 /
MK 3)
The AdBlue warning light that appears on the instrument panel of the Renault Master can be reset by first topping up the AdBlue fluid, adding the nec…
Other guides you may be interested in
|
Frequently Asked QuestionsHow to Remove the Rear Seat of a Hyundai Tucson?
To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.059
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |