|
Do it yourself
| |||
| ||||
How to Change the Oil and Filter on the Renault Trafic
Model: Renault Trafic
MK 3
- Years 2014-2026
On the Renault Trafic, to correctly perform the oil change and filter replacement, always work with the engine warm and safely: vehicle on level ground, handbrake engaged, and if needed, use approved axle stands. Prepare a collection bowl, gloves, and all necessary equipment, as the oil can be hot and easily spill. Locate the drain plug on the Renault Trafic's sump and position the bowl underneath. Unscrew the plug, allowing the oil to fully drain, and wait a few minutes until the flow reduces. Meanwhile, move to the oil filter on the Renault Trafic: remove it with the appropriate tool, being careful of any residual drips. Before fitting the new filter, check that the old seal is not left in place, then lightly lubricate the new filter seal with a thin layer of oil and screw it in until it is snug, tightening without overdoing it. Close the drain by refitting the plug, then top up the oil through the filler cap using the correct specification for the Renault Trafic (quantity and grade may vary depending on the engine, so refer to the handbook or your engine code data). Start the Renault Trafic for a few seconds, switch off, and check for any leaks around the filter and drain. After a few minutes, check the level with the dipstick and adjust it between minimum and maximum.
Posted on 6 July 2026 by ScegliAuto
Video tutorial
Related tutorials
Renault Trafic
(2014-2026 /
MK 3)
To change the engine oil and filter on a Renault Trafic, position the vehicle on a flat surface and safely lift it to access the underside. Place a c…
Renault Trafic
(2001-2014 /
MK 2)
To change the oil on the Renault Trafic II, we open the hood, lift the front of the car, and then open the oil filler cap to facilitate draining. We …
Renault Trafic
(2001-2014 /
MK 2)
The steps to replace the diesel filter of the Renault Trafic model 2 are not very complex to do independently. Let's start by dismantling the filter …
Other guides you may be interested in
|
How to Reset the Central Locking of the Volkswagen Golf 4?
If the central locking system of the Volkswagen Golf 4 is not working, it is likely necessary to reset the system: to do this, open the driver's door and detach the side panel of the dashboard next to the steering wheel. Under this panel, you will find the fuses, including the one for the central locking, which is indicated in the manual as number 14. To reset the system, remove this fuse from its housing, then reinsert it or replace it with a new one of the same amperage: this will reset the central locking system. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.067
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |