|
Do it yourself
| |||
| ||||
How to Replace the EGR Valve on the Renault Clio 1.5 dCi?
Model: Renault Clio
Clio IV, MK 4, Clio 4
- Years 2012-2019
To replace the EGR valve on the Renault Clio 1.4 dCi, open the bonnet to access the engine compartment. The valve is located at the top of the engine bay, just below the windscreen. To remove it, disconnect the electrical connector from the air mass meter and unscrew the securing rings. This will allow you to remove the air duct; next, loosen the bolts securing the turbo air duct and detach the breather duct from its clips. Then, accessing from underneath the car, you can also loosen the bolts securing the lower part of the turbo air duct. By removing the duct from the top of the car, you will gain access to the EGR valve: after disconnecting the connector, unscrewing the fixing bolts, and removing the coolant hose, the valve can be removed and replaced.
Updated on 15 May 2026 by ScegliAuto
Video tutorial
Related tutorials
Renault Clio
(2005-2013 /
MK 3, Clio 3, Clio III)
The EGR valve on the Clio III 1.5 dCi tends to clog with carbon, causing a loss of power and engine warning light. To clean it, remove the intake man…
Renault Clio
(2005-2013 /
MK 3, Clio 3, Clio III)
As shown in the video, open the engine bay of your Renault Clio 3 1.5 dCi and remove the engine cover. At this point, you will see the EGR valve conn…
Renault Clio
(2012-2019 /
Clio IV, MK 4, Clio 4)
To remove and replace the EGR valve on the vehicle, follow these steps: open the bonnet, loosen the hose clamp securing the air intake pipe from the …
Other guides you may be interested in
|
Where is the Fuel Filter Located in a Volvo XC60?
In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.229
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |