|
Do it yourself
| |||
| ||||
Replacement of Timing Belt
Model: Renault Clio
Clio 2, MK 2
- Years 1998-2005
Replacing the timing belt is not typically a DIY maintenance task, but if you have good general mechanical knowledge, you can attempt it. It is recommended from the outset not to lose the timing references. Start by lifting the vehicle to remove the front right wheel and its wheel arch liner. Remove the protective grille under the radiator and disconnect the hose to drain the coolant. Disconnect the negative terminal of the battery, remove the lower engine mount, and place a jack under the engine to support it while removing the side engine mount and the plastic cover of the timing belt. Rotate the crankshaft pulley to align the timing marks, loosen the tensioner, and remove the toothed belt. Next, proceed to remove the tensioner and water pump, then reinsert the toothed belt, ensuring the timing marks are maintained. Reassemble everything and refill the cooling system with antifreeze before starting the engine.
Updated on 18 February 2026 by ScegliAuto
Video tutorial
Related tutorials
Renault Clio
(2012-2019 /
Clio IV, MK 4, Clio 4)
Today we will discover the instructions that will allow us to dismantle and replace the timing belt of the Renault Clio 1.2 petrol. First, we open th…
Renault Clio
(2012-2019 /
Clio IV, MK 4, Clio 4)
Below we will discover the information that will illustrate the procedure for dismantling and replacing the timing belt of the Renault Clio 1.5 dCi. …
Renault Clio
(2005-2013 /
Clio 3, Clio III, MK 3)
The following steps will show us how to disassemble and replace the timing belt of the Renault Clio 1.2 petrol. First, we lift the vehicle and begin …
Other guides you may be interested in
|
Frequently Asked QuestionsRemoving the Door Panel on Ypsilon
Remove the door panel of the Lancia Ypsilon to access the speaker? Follow this guide to see how to do it. Unscrew all the securing screws located inside the cover panel. Disconnect the securing clips. Finally, pull the panel away with your hands and detach it from the door (disconnect the power wiring and the opening cable). Remove the speaker from inside the door. Refit the panel onto the car door and screw in the screws. Don't forget to reconnect the power terminals behind the panel before refitting it. Test the operation of the newly installed speaker. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.109
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |