Do it yourself
Frequently asked questions about cars and motorcycles

Procedure for replacing the engine oil and oil filter in a Renault Megane 1.4 TCE.

Model: Renault Megane Megane 3, Megane III - Years 2008-2015
Part: Engine oil

Get into the car, turn off the engine, and engage the handbrake; lift the car using a hydraulic jack and place safety stands; remove the 10 mm screws and bolts securing the engine undertray, then slide the tray backward to remove it. Use a 14 mm socket wrench to unscrew the engine oil drain plug (wear disposable gloves to avoid getting dirty). Position a container under the oil drain plug and wait for all the oil to drain. Remove the oil plug and dipstick to allow better drainage. Remove the oil filter, located near the oil pan (use an oil filter wrench, turning counterclockwise). Place a basin under the filter to collect the oil that comes out. Take the new oil filter and lubricate the gasket with clean oil; screw the new oil filter into place (hand tighten and then give it a half turn with the wrench to secure it properly). Screw the drain plug back in with the new gasket, without overtightening. Lower the vehicle and use a funnel to refill with new "SAE 5W-40" oil (4.4 liters of oil).

Posted on 22 August 2023 by ScegliAuto

Video tutorial

Related tutorials

Renault Megane (2008-2015 / Megane 3, Megane III) Let's see through this short tutorial today how to replace the air filter on a third-generation Renault Megane 1.4 TCe, model produced from 2008 to 2…
Renault Megane (2002-2010 / Megane 2) The notification for the expiration of the service sticker available in the Renault Megane 2 is similar to that of other cars; it is represented by a…
Renault Megane (2008-2015 / Megane 3, Megane III) If you want to replace one of the bulbs located inside the rear light of your Renault Megane Mk3, all you have to do is follow the procedure describe…

Other guides you may be interested in

How to Install an Additional Horn on a Fiat Punto

It may happen that the original horn starts to produce a sound that is noticeably underwhelming; at this point, you can decide to install a pair of sounders connected in parallel with the original one to achieve a more assertive sound. The installation is very easy, but it is important to direct the sound output towards an air intake, so you need to shape a support bracket to fix it to the slam panel with a single bolt. Once secured, take the positive power from the fuse box using a 2.5 mm² cable, tapping into the purple wire directly under the relay while connecting the ground directly to the negative terminal of the battery.

Watch the video!


by ScegliAuto

More videos