Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Subaru
    3. :
  3. Forester
    4. : Starter motor replacement

Subaru Forester - Video tutorial

Model: Subaru Forester MK 2, SG - Years 2002-2008
Part: Starter motor
Operation: Starter motor replacement

Before proceeding with the disassembly of the starter motor, disconnect the negative pole of the battery; the motor is located on the right side of the motor (looking from the front), immediately above the gearbox: therefore disconnect the positive power supply of the solenoid and proceed with the disassembly of the fixing pins of the motor itself (the one found in the lower part is a slightly more difficult to unscrew, then use a screwdriver to leverage the motor from its seat and proceed backwards to install the new motor In any case, it is advisable to opt for a regenerated motor rather than a new or used one.


Posted on 19 July 2023 by ScegliAuto



Clutch replacement instructions
Subaru Forester (2002-2008 / MK 2, SG) Replacing the clutch requires good knowledge of general mechanics and some tools; then lift the car on the lift and start removing the front section
How to replace the cabin fan on Subaru Forester
Subaru Forester (2008-2011 / MK 3, SH) In this video we will see the instructions to be able to disassemble and replace the passenger compartment fan on a Subaru Forester third series, fol
Engine oil and oil filter replacement
Subaru Forester (2002-2008 / MK 2, SG) Raise the car on special car platforms for easier access to the oil pan; remove the plastic flap to access the drain plug and the filter, place a tra

Other guides that may interest you

How to reset the oil change light on Kymco Agility 125

If we have done the oil change on this type of scooter in do-it-yourself mode, we need to complete the job by resetting the oil change light that came on in the instrument panel display. In the description below we can find the necessary steps to do this. First you need to insert the key on the ignition switch and turn on the ignition. Then show the total mileage on the display and then press the two buttons at the bottom of the panel at the same time until the oil change light goes off.

Watch the video!


by ScegliAuto

More videos