Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Front Brake Pads on the Subaru Forester MK4

Model: Subaru Forester MK 4, SJ - Years 2012-2019
Part: Brake pads

Below are the instructions necessary for removing and replacing the front brake pads on the fourth generation Subaru Forester. Start by lifting the vehicle and removing the front wheel; then unscrew the bolts securing the front brake caliper, which are located at the rear, as shown in the video. At this point, lever the piston back slightly to remove the caliper and replace the brake pads; clean the caliper of any residual dirt and refit the new brake pads!

Updated on 9 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Brake Pads on the Subaru Forester 2
How to Replace the Brake Pads on the Subaru Forester 2
Subaru Forester (2002-2008 / SG, MK 2) This video shows how to remove and replace the brake pads, whether front or rear, on the second series Subaru Forester. First, lift the vehicle and r…
Replacing the front headlight bulb on the Subaru Forester MK4
Replacing the front headlight bulb on the Subaru Forester MK4
Subaru Forester (2012-2019 / MK 4, SJ) Today, we will go through the steps to disassemble and replace the front headlight bulb on the fourth generation Subaru Forester, specifically the 20…
Replacing the Front Bumper of the Subaru Forester
Replacing the Front Bumper of the Subaru Forester
Subaru Forester (2012-2019 / MK 4, SJ) Today, we will discover the key information for removing and replacing the front bumper of the Subaru Forester. First, open the vehicle's bonnet and …

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos