Do it yourself
Frequently asked questions about cars and motorcycles

Replacing the Lambda Sensor on a Suzuki Jimny

Model: Suzuki Jimny Jb23, Jb33, Jb43, Jb53 - Years 1998-2018
Part: Oxygen sensor

This guide outlines the procedure to remove and replace the lambda sensor on a Suzuki Jimny in simple and quick steps. First, open the bonnet of your car and locate the lambda sensor, which is found on the right side of the engine (on the exhaust manifold); then use a socket spanner to unscrew the oxygen sensor, disconnecting its electrical connector to remove it, as shown in the video. At this point, install the new lambda sensor, then reset the warning light that appears on the dashboard!

Updated on 12 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Suzuki Jimny (1998-2018 / Jb23, Jb33, Jb43, Jb53) In order to replace the lambda sensor of the Suzuki Jimny, you need to open the hood so that you can access the inside of the engine compartment: her…
Suzuki Jimny (1998-2018 / Jb23, Jb33, Jb43, Jb53) Before you can start, open the bonnet of your Suzuki Jimny. Begin by loosening the tensioner by slightly unscrewing the fixing bolt. This will free t…
Suzuki Jimny (1998-2018 / Jb23, Jb33, Jb43, Jb53) This guide outlines the main steps and instructions for replacing the timing belt of the first series Suzuki Jimny; typically, the timing belt should…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos