Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Light Bulb on a Tata Zest?

Model: Tata Zest MK 1 - Years 2014-2019
Part: Tail light bulb

To replace the rear light bulb on a Tata Zest, open the trunk lid to detach the carpet cover located near the light. Once removed, you can unscrew the underlying screw so that the light can be completely extracted from its housing. Then, by disconnecting the connector, you can pull out the bulb from its housing to replace it with a new one. This should be connected to the connector and inserted back into the light, which should then be secured with the appropriate screw inside the trunk.

Updated on 24 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Headlight Bulb on a Tata Zest?
How to Replace the Headlight Bulb on a Tata Zest?
Tata Zest (2014-2019 / MK 1) To replace the headlight bulb on a Tata Zest, open the hood to access the components inside the engine compartment. The bulb is located inside the he…
How to Reset the Service Light in a Tata Zest?
How to Reset the Service Light in a Tata Zest?
Tata Zest (2014-2019 / MK 1) As shown in this tutorial, resetting the service light in a Tata Zest is a very simple and quick operation. Before proceeding, make sure to complete …
How to Reset the Service Light in a Tata Zest?
How to Reset the Service Light in a Tata Zest?
Tata Zest (2014-2019 / MK 1) As seen in this tutorial, resetting the service light in a Tata Zest is a very simple and quick operation. Before proceeding, ensure that all schedul…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos