Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Engine Oil and Filter of the Toyota Camry XV50

Model: Toyota Camry Xv50 - Years: 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019
Part: Engine oil

See other generations:
Video tutorial

This guide shows how to perform the engine oil replacement for the Toyota Camry XV50. The first step is to open the hood and remove the oil filler cap. Once the vehicle is safely lifted, locate the oil filter position and remove the protective cap, after placing a container under the vehicle.

Insert the drain spout into the opening created and wait for the lubricant to drain from the filter cartridge.

Using a 14mm wrench, remove the drain plug from the oil pan and let all the fluid drain out. After removing the drain spout, use the filter removal tool to loosen the mount. Pull out the cartridge and discard the gasket.

Clean the containment pan of the cartridge and the upper block. Install the new cartridge and gasket, lubricating this component.

Reattach the cartridge mount and tighten it to the specified torque in the owner's manual. Lubricate the replacement gasket of the filter drain plug and reinstall it. Close the oil pan cap and clean up any oil residue.

Lower the vehicle and refill with engine oil. Start the engine for a few minutes and check the fluid level.


Updated on 3 May 2026 by ScegliAuto


Related tutorials

Toyota Camry (2011-2019 / Xv50) Replacing the cabin air filter in the Toyota Camry XV50 is a very simple and quick task. The filter is located behind the glove compartment on the pa…
Toyota Camry (2011-2019 / Xv50) To change the engine oil filter in a Toyota Camry, lift the front of the vehicle using a jack and place safety stands. Position a container under the…
Toyota Camry (2011-2019 / Xv50) In this video tutorial, you will learn how to remove and replace the battery in a Toyota Camry XV50 by following the instructions below. First, open …

Other guides you may be interested in

How to open the bonnet on a Volkswagen Golf?

In this tutorial, you will see how to open the bonnet on a Volkswagen Golf MK4. This is a very simple operation that follows the standard procedure. First, open the driver's door, then locate the lever in the lower left area and pull it. Next, move to the front of the vehicle, lift the bonnet slightly, and find the second lever located just above the Volkswagen logo. At this point, simply pull it towards you, fully open the bonnet, and secure it with the prop rod. To close it, gently push it down.

Watch the video!


by ScegliAuto

More videos