Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Toyota
    3. :
  3. Yaris
    4. : How do you replace the diesel fuel filter in the Toyota Yaris 2?

Toyota Yaris - Video tutorial

Model: Toyota Yaris Xp90 - Years 2005-2011
Part: Diesel filter
Operation: How do you replace the diesel fuel filter in the Toyota Yaris 2?

The fuel filter is located in the front of the car, so in order to replace it, we need to first open the engine compartment and also remove the battery. Now we can access the fuel filter and, using a flat pliers, disconnect the hoses. Afterwards, we also need to disconnect the electrical connector and unscrew the filter fixing nut with a socket wrench. Remove the filter, empty it, and use a locking pliers to remove the sensor on the filter. Replace the sensor gasket and then install it on the new filter. Finish the procedure by installing the new filter: to do this, we just need to follow the steps of this guide in reverse.


Posted on 13 October 2023 by ScegliAuto

    Frequently Asked Questions

    • Yaris 2005-2011 - Where is the fuel filter of the Toyota Yaris located? Read Answer
    • Yaris 1999-2005 - Where is the Toyota Yaris diesel filter located? Read Answer
    • Yaris 2005-2011 - Where is the Toyota Yaris diesel filter located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos