Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Dipped Beam Bulb on a Yamaha T Max

Model: (Various brands) Various
Part: Tail light bulb

If you need to replace a bulb in the front headlight of the scooter, follow the simple instructions below and refer to the video. Reach behind the headlight from under the fairing, locate the rubber rain cover, and remove it. Underneath, you will find the steel clip that holds the bulb in place. Press it and flip it down to release the bulb. At this point, you can extract the bulb. Take the new bulb, being careful not to touch the glass with your fingers, place it in the housing, reattach the steel clips, and reposition the rubber cover.

Updated on 21 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Short and Long Bulbs on a Yamaha X Max 125
How to Change the Short and Long Bulbs on a Yamaha X Max 125
(Various brands) Various To change the bulb on a Yamaha X Max 125, as shown in the video, you will need a 4 mm spanner, a 10 mm spanner, a Phillips screwdriver, and of course…
How to replace the rear headlight bulb of a car
How to replace the rear headlight bulb of a car
(Various brands) Various Replacing the bulb of the left rear headlight of the car is a very simple and quick operation to perform independently, and this operation is similar…
How to Reset the Oil Warning Light on the Yamaha X Max 300
How to Reset the Oil Warning Light on the Yamaha X Max 300
(Various brands) Various To reset the oil warning light on the Yamaha X Max 300, follow these steps: Turn off the ignition of the X Max, press and hold the mode and set butto…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos