Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change a Wheel

Model: (Various brands) Various
Part: Wheel

In this video, learn how to change a wheel in case of necessity: the system is the same for all cars, with a few differences in the location of various accessories (and for this reason, it's a good idea to check the owner's manual). Remember to keep the vehicle well secured, so engage the handbrake and put the car in gear! Usually, there is a specific tool for removing the wheel covers, and if there is a locking bolt, remember that there is a special key to remove it. Start by loosening the bolts with the wheel on the ground (perhaps using your legs for leverage). The jack must be placed on the designated lifting point, which should be identified before placing it, then extend the jack and use the lifting lever. Remove the wheel and replace it with the spare. Replace the bolts, tightening them gradually, lower the car, and remember that the spare has a speed limit of 80 mph.

Updated on 17 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Change a Motorcycle Sprocket
How to Change a Motorcycle Sprocket
(Various brands) Various The sprocket is one of the motorcycle components most subject to wear, so it is important to know how to change it. After placing the motorcycle on a…
How to Change a Car Wheel?
How to Change a Car Wheel?
(Various brands) Various Have you got a flat tyre and don’t want to spend money on a tow truck to take the car to the tyre shop? Learn how to change the wheel yourself with t…
How to change the time on a Kymco Xciting 300
How to change the time on a Kymco Xciting 300
(Various brands) Various If you need to change the time set on the dashboard of your motorcycle, you will find the necessary instructions and steps in the description below, …

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos