Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Front Wheel of the Beverly

Model: (Various brands) Various
Part: Wheel

Removing the front wheel of the Beverly is very simple; this maintenance task can be performed independently in a few easy steps. Start by lifting the scooter with a jack placed under the tank protection bar, so that the front wheel is off the ground. Continue by unscrewing the wheel nuts using an electric wrench from both sides. Remove the central axle pin using a large hex key. At this point, slide the wheel forward and take it out. Before fitting a new wheel onto the rim, lubricate it to facilitate installation. Insert the wheel and then proceed with reassembly, following the previous instructions but in reverse.

Updated on 7 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Front Wheel of a Vespa
How to Remove the Front Wheel of a Vespa
(Various brands) Various In this video, you will learn how to remove the front wheel of a Vespa. First, position the Vespa in a way that allows you to comfortably remove the …
How to Remove the Front Wheel of My Motorcycle?
How to Remove the Front Wheel of My Motorcycle?
(Various brands) Various Removing the front wheel of a motorcycle is much easier than the rear wheel. This brief guide shows you how to do it in simple steps. The procedure m…
Replacing the Front Wheel Bearing
Replacing the Front Wheel Bearing
(Various brands) Various Let's look at replacing the front wheel bearing of the car. Lift the car with a jack, remove the wheel to access the wheel hub. Undo the bolts of the…

Other guides you may be interested in

How to Open the Bonnet of a Renault Megane if the Lever is Broken?

If the lever that unlocks the bonnet of the Renault Megane is broken or not functioning, there is an emergency procedure to unlock the mechanism: remove the right front grille located at the top of the bumper. Once the grille is removed, you can locate the actuator mechanism: by pulling the spring in this position, you can unlock the actuator, allowing you to lift the bonnet and access the components located inside the engine compartment. You can then close the bonnet simply by lowering it.

Watch the video!


by ScegliAuto

More videos