Do it yourself
Frequently asked questions about cars and motorcycles

Removing the Front Panel on Volkswagen Passat

Model: Volkswagen Passat MK 8, 3G, B8 - Years: 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023
Part: Door trim panel

See other generations:
Video tutorial

To begin, remove the cover of the central handle by prying in the gaps with a plastic wedge, then unscrew the bolts underneath. Next, move to the back of the door and remove the three bolts located in this area, as shown in the video.

Done! Now you can get a plastic lever or a flat screwdriver and pry around the entire area, pulling the panel out a bit at a time. Finally, disconnect the cables and remove it completely.

For fitting a new door panel, simply reverse the process.


Updated on 13 April 2026 by ScegliAuto


Related tutorials

Volkswagen Passat (2005-2010 / B6, 3C) In today's video, you will see the main instructions for removing the wheel arch and front wing of a Volkswagen Passat B6. First, remove all the scre…
Volkswagen Passat (2010-2014 / B7) How to remove the front headrest from a Volkswagen Passat? This video explains the procedure: open the door and enter the front or rear (depending on…
Volkswagen Passat (1996-2005 / 3BG, B5) This guide will outline the main steps to remove and replace the front driveshaft boot on the Volkswagen Passat. First, lift the vehicle and start by…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

How to adjust the headlights in the Toyota RAV4?

In this tutorial, you can see how to adjust the headlights in the Toyota RAV4, a very simple and quick operation. First, position the vehicle in front of a wall, about 40 centimetres away, then switch on the headlights and open the bonnet. Next, locate the small hole on both headlamps, apply tape on the wall at the same height, and using the indicated adjustment ring, position the beam of light so that it is perpendicular to the tape. Finally, move the vehicle back and check that the beam falls below the tape; if not, lower it slightly.

Watch the video!


by ScegliAuto

More videos