Do it yourself
Frequently asked questions about cars and motorcycles

Replacing the Front Driveshaft Boot on the Volkswagen Passat

Model: Volkswagen Passat 3BG, B5 - Years: 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005
Part: CV boot

See other generations:
Video tutorial

This guide will outline the main steps to remove and replace the front driveshaft boot on the Volkswagen Passat. First, lift the vehicle and start by removing the front wheel.

Then, unscrew the nut from the arm pivot, disconnecting the braking system from the front driveshaft, as shown in the video. Next, remove the driveshaft boot and replace it with the correct new one; insert it in the correct orientation on the driveshaft and reassemble everything by following the reverse procedure of disassembly!


Updated on 23 June 2026 by ScegliAuto


Related tutorials

Volkswagen Passat (1996-2005 / 3BG, B5) This video explains how to replace the joint and the corresponding boot of a Volkswagen Passat driveshaft. In the initial images, a new joint is comp…
Volkswagen Passat (2005-2010 / B6, 3C) This video shows how to replace the boot or the complete driveshaft. First, lift the car on a jack and remove the nuts to take off the wheel; then un…
Volkswagen Passat (2005-2010 / B6, 3C) Obtain a replacement half shaft, then lift the vehicle securely and start by removing the wheel. The necessary tools are: a set of spanners, a 5mm Al…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

How to adjust the headlights in the Toyota RAV4?

In this tutorial, you can see how to adjust the headlights in the Toyota RAV4, a very simple and quick operation. First, position the vehicle in front of a wall, about 40 centimetres away, then switch on the headlights and open the bonnet. Next, locate the small hole on both headlamps, apply tape on the wall at the same height, and using the indicated adjustment ring, position the beam of light so that it is perpendicular to the tape. Finally, move the vehicle back and check that the beam falls below the tape; if not, lower it slightly.

Watch the video!


by ScegliAuto

More videos