Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Inspection and Replacement of a Driveshaft Joint

Model: Volkswagen Passat 3BG, B5 - Years: 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005
Part: Axle shaft

See other generations:
Video tutorial

This video explains how to replace the joint and the corresponding boot of a Volkswagen Passat driveshaft. In the initial images, a new joint is compared with a worn one: it is evident that in the second, the boot is very worn and the tears compromise its functionality.

If the entire driveshaft needs to be replaced and not just a part of it, the video shows what a complete kit should contain. It then shows a tool specifically designed to separate the joint from the driveshaft: it is a wooden tool shaped like an 'F' that, using gravity, should allow for separation.

In reality, it is not strong enough, so another tool that also uses a clamp is employed: this way, the joint is detached. In this case, the joint is in good condition, so it is cleaned internally, re-greased, and covered with a new boot.

If the joint needs to be disassembled, mark the points with a small circular saw to remember how to reassemble it in the correct position. After opening the joint and extracting, cleaning, and greasing each part, reassemble it as before.

Finally, remember to tighten the clamps that connect the joint to the driveshaft.


Updated on 8 February 2026 by ScegliAuto


Related tutorials

Replacing the Front Driveshaft Boot on the Volkswagen Passat
Replacing the Front Driveshaft Boot on the Volkswagen Passat
Volkswagen Passat (1996-2005 / 3BG, B5) This guide will outline the main steps to remove and replace the front driveshaft boot on the Volkswagen Passat. First, lift the vehicle and start by…
Steering Rack Tie Rod End Replacement
Steering Rack Tie Rod End Replacement
Volkswagen Passat (1996-2005 / 3BG, B5) To replace the spherical tie rod end of the steering rack, lift the vehicle on a hydraulic lift and remove the front wheel; then remove the fixing pi…
Replacing the Driveshaft Boot
Replacing the Driveshaft Boot
Volkswagen Passat (2005-2010 / B6, 3C) This video shows how to replace the boot or the complete driveshaft. First, lift the car on a jack and remove the nuts to take off the wheel; then un…

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos