Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Automatic Gearbox Solenoid Valve

Model: Volkswagen Sharan 7M, MK 1 - Years: 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006
Part: Drivetrain

See other generations:
Video tutorial

If you experience problems with the automatic gearbox, first perform a diagnostic check to assess the type of fault recorded. Specifically, the diagnosis indicates a fault related to a solenoid valve located within the gearbox, which is relatively simple to replace.

First, remove the plate to which the gear lever rod is connected, then lift the vehicle on a ramp and remove the cover positioned in front of the gearbox. The two solenoid valves are located at the bottom right, and the fault refers to the upper one. Disconnect the connectors, remove the retaining pins, take out the valves complete with support, and replace the faulty one. After installation, clean the cover and apply gasket sealant before refitting it. Finally, clear the fault memory.


Updated on 14 February 2026 by ScegliAuto


Related tutorials

Replacing the Window Switch Panel
Replacing the Window Switch Panel
Volkswagen Sharan (1995-2010 / 7M, MK 1) The first step to replace the window switch panel in your car is to buy a new one. Following this guide, the replacement procedure can be carried out…
How to replace the rear headlight bulb of the VW Sharan
How to replace the rear headlight bulb of the VW Sharan
Volkswagen Sharan (1995-2010 / 7M, MK 1) The steps to replace the rear headlight bulb of a Volkswagen Sharan model m7 are simple and quick to do independently. The first step is to open the …
Replacing Cabin Air Filter
Replacing Cabin Air Filter
Volkswagen Sharan (1995-2010 / 7M, MK 1) The cabin air filter is located on the passenger side, just below the glove compartment: to replace it, first remove the carpet covering secured by t…

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos