Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Polo
    4. : Replacement of the starter motor of the Volkswagen Polo 1.4

Volkswagen Polo - Video tutorial

Model: Volkswagen Polo Polo 4, MK 4, Polo IV, 9N, MK IV - Years 2001-2009
Part: Starter motor
Operation: Replacement of the starter motor of the Volkswagen Polo 1.4

In this guide, we will see the instructions that will allow us to disassemble and replace the starter motor of the Volkswagen Polo 1.4. First of all, we open the car's engine hood and start by removing the air intake hose; then we find our starter motor at the bottom, where we will unscrew its fixing screws and disconnect its electrical connector to remove it, as shown in the video. At this point, we carry out the repair or directly replace the component with the new original one, following the video tutorial until the end!


Posted on 24 February 2024 by ScegliAuto

    Frequently Asked Questions

    • Polo 2009-2017 - What is the cost for replacing the starter motor in the Volkswagen Polo? Read Answer
    • Polo 2009-2017 - What is the position of the starter on the Volkswagen Polo? Read Answer
    • Polo 2017-2025 - What is the cost of replacing the starter motor in the Volkswagen Polo? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos