Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Polo
    4. : How do you replace the starter motor on the Volkswagen Polo?

Volkswagen Polo - Video tutorial

Model: Volkswagen Polo Polo III, Polo 3, MK III, 6N, MK 3 - Years 1994-2003
Part: Starter motor
Operation: How do you replace the starter motor on the Volkswagen Polo?

In order to replace the starter motor of the Volkswagen Polo, you need to go and open the bonnet in order to have access to the components inside the engine compartment. The starter motor will be located in the lower area of the engine compartment and to reach it it will be necessary to go and remove several components. Once these have been removed, it will be possible to access the motor which must be released from its housing and disconnected from the connectors so that a new one can be inserted. After the installation you will be able to mount all the removed components again.


Posted on 5 December 2022 by ScegliAuto

    Frequently Asked Questions

    • Polo 2009-2017 - What is the cost for replacing the starter motor in the Volkswagen Polo? Read Answer
    • Polo 2009-2017 - What is the position of the starter on the Volkswagen Polo? Read Answer
    • Polo 2017-2025 - What is the cost of replacing the starter motor in the Volkswagen Polo? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos