Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installation of Front Spoiler

Model: Volvo S60 MK 2 - Years 2010-2018
Part: Body

If possible, lift the vehicle with a lift to facilitate the installation process. Unscrew all the screws along the lower edge of the bumper. Apply the drilling templates and double-sided tape inside the spoiler to ensure that when positioning the spoiler for installation, the templates remain stuck to the bumper at the points where the holes will be drilled. Drill with a 5mm bit, remove the templates, and enlarge the holes with an 8mm bit. Install the push clips inside the spoiler, remove the protective film from the double-sided tape, and install the spoiler by inserting the push clips, ensuring the double-sided tape adheres properly, and re-screwing the previously removed screws.

Updated on 4 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Installing Chrome Exhaust Tips and Aluminum Effect Spoiler
Installing Chrome Exhaust Tips and Aluminum Effect Spoiler
Volvo S60 (2010-2018 / MK 2) Lift the vehicle on a lift and remove the lower spoiler from the rear bumper: there are four Torx screws size T28 and clips along the entire edge to …
How to Replace the Timing Belt on a Volvo S60?
How to Replace the Timing Belt on a Volvo S60?
Volvo S60 (2000-2009 / MK 1) To replace the timing belt on a Volvo S60, first remove the right front wheel and the inner fender cover to access the pulley. Loosen the central bol…
How to replace the serpentine belt on the Volvo S60?
How to replace the serpentine belt on the Volvo S60?
Volvo S60 (2010-2018 / MK 2) To replace the serpentine belt on the Volvo S60, lift the car with a jack or a lift so you can loosen the bolts securing the front right wheel. Once …

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos