Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volvo
    3. :
  3. V70
    4. : How do you replace the Volvo V70 mirror bulb?

Volvo V70 - Video tutorial

Model: Volvo V70 MK 2 - Years 2000-2007
Part: Side turn signal light bulb
Operation: How do you replace the Volvo V70 mirror bulb?

To be able to replace the wing mirror bulb of the Volvo V70 you have to pry with an object such as a screwdriver, so that the ceiling light in the lower part of the mirror can be extracted. After this has been removed from its housing, it will be necessary to disconnect the connector connected to it and remove the bulb located inside. This can therefore now be replaced with a new spare part, which must be suitably inserted in the ceiling light; finally it will be necessary to connect the latter to the connector and insert it in its housing in the mirror.


Posted on 15 December 2022 by ScegliAuto



How to replace the turn signal on the Volvo V70 side mirror
Volvo V70 (2007-2016 / MK 3) Today we will see, in this video tutorial, how to disassemble and replace the exterior rear view mirror turn signal on a Volvo V70. First of all, let
How to replace the glass of the external rearview mirror of the Volvo V70?
Volvo V70 (2007-2016 / MK 3) The procedure shown here for replacing the glass of an external rearview mirror in a Volvo V70 is valid not only for similar models of the Volvo car
Replacement of the external rearview mirror of the Volvo V70.
Volvo V70 (2000-2007 / MK 2) Today's guide will show us how to disassemble and replace the external rearview mirror of the Volvo V70, following the instructions below. First, we

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos